I added Hatch under Add Modifier → Shapes & Utilities. Hatch the interior of closed outlines.
How to use Hatch
- Select the layer whose linework you want to transform
- Open Studio → Add Modifier → Shapes & Utilities → Hatch
- A modifier node is appended to the layer stack (non-destructive)
- Reorder modifiers in the stack; later modifiers see earlier output
- Tune parameters in the modifier card in the right sidebar; preview updates on the canvas
Menu path: Add Modifier → Shapes & Utilities → Hatch
Key controls
- Acts On: own, options: This Layer, This Layer and Below
- Hatch: diagonal, options: Horizontal, Vertical, Diagonal...
- Spacing: 2mm (0.3-20mm step 0.1)
- Angle: 45° (0-180° step 1)
- Close Gap: 1mm (0-20mm step 0.5)
Tune acts on, hatch, spacing, angle, and close gap in the right sidebar. Open Studio to see every control.
Modifier stack: May add, drop, or reorder paths; selection maps reset for this layer
Acts On: Choose *This Layer* or *This Layer and Below* in the right sidebar.
What I plot with Hatch
- Pen-plotter art on Bambu Lab, Prusa, Creality, and other pen-holder setups
- Layered linework exported as G-code with pen-up travel
- Combined with other V3 objects and modifiers in the same document
Frequently asked questions
Where is Hatch in the menu?
Add Modifier → Shapes & Utilities → Hatch
What can I adjust?
Start with the key controls above, then fine-tune everything else in the right sidebar inside Studio.
Is this non-destructive?
Yes. Modifiers run on the layer stack without destroying source elements. Reorder or remove the modifier node to revert.
Does Hatch work with multi-pen plotting?
Yes. Use Pen Palette on a layer to split linework by color, or set per-path ink on modifiers like Offset.
Try Hatch
Open 3DPlotter Studio, follow the steps above, and export a test plot. Lifetime V3 access is €29.90. Creator Bundle (€39.90) adds Map to Pen Plot, String Art, Wax Seal, and 3D Model to SVG.
More tools: Feature hub · V3 launch